Ikari, Matt J. and Saffer, Demian M. (2012): Permeability contrasts between sheared and normally consolidated sediments in the Nankai accretionary prism

Leg/Site/Hole:
IODP 316
ODP 190
IODP 314 C0001
IODP 315 C0001
IODP 314 C0004
IODP 316 C0004
IODP 316 C0008
ODP 190 1173
ODP 196 1173
ODP 190 1174
Identifier:
2012-045484
georefid

10.1016/j.margeo.2011.11.006
doi

Creator:
Ikari, Matt J.
Pennsylvania State University, Department of Geosciences, University Park, PA, United States
author

Saffer, Demian M.
author

Identification:
Permeability contrasts between sheared and normally consolidated sediments in the Nankai accretionary prism
2012
Marine Geology
Elsevier, Amsterdam, Netherlands
295-298
1-13
At subduction zones, the permeability of major fault zones influences pore pressure generation, controls fluid flow pathways and rates, and affects fault slip behavior and mechanical strength by mediating effective normal stress. Therefore, there is a need for detailed and systematic permeability measurements of natural materials from fault systems, particularly measurements that allow direct comparison between the permeability of sheared and unsheared samples from the same host rock or sediment. We conducted laboratory experiments to compare the permeability of sheared and uniaxially consolidated (unsheared) marine sediments sampled during IODP Expedition 316 and ODP Leg 190 to the Nankai Trough offshore Japan. These samples were retrieved from: (1) The decollement zone and incoming trench fill offshore Shikoku Island (the Muroto transect); (2) Slope sediments sampled offshore SW Honshu (the Kumano transect) approximately 25km landward of the trench, including material overriden by a major out-of-sequence thrust fault, termed the "megasplay"; and (3) A region of diffuse thrust faulting near the toe of the accretionary prism along the Kumano transect. Our results show that shearing reduces fault-normal permeability by up to 1 order of magnitude, and this reduction is largest for shallow (<500mbsf) samples. Shearing-induced permeability reduction is smaller in samples from greater depth, where pre-existing fabric from compaction and lithification may be better developed. Our results indicate that localized shearing in fault zones should result in heterogeneous permeability in the uppermost few kilometers in accretionary prisms, which favors both the trapping of fluids beneath and within major faults, and the channeling of flow parallel to fault structure. These low permeabilities promote the development of elevated pore fluid pressures during accretion and underthrusting, and will also facilitate dynamic hydrologic processes within shear zones including dilatancy hardening and thermal pressurization. Abstract Copyright (2012) Elsevier, B.V.
English
Serial
Coverage:Geographic coordinates:
North:34.0000
West:134.0000East: 137.0000
South:32.0000

Oceanography; accretionary wedges; Asia; cores; eastern Japan; Expedition 316; experimental studies; Far East; Integrated Ocean Drilling Program; IODP Site C0001; IODP Site C0004; IODP Site C0008; Japan; laboratory studies; Leg 190; marine sediments; Nankai Trough; NanTroSEIZE; North Pacific; Northwest Pacific; Ocean Drilling Program; ODP Site 1173; ODP Site 1174; Pacific Ocean; permeability; sediments; shear stress; spatial variations; subduction zones; West Pacific;

.